Configuration for Ascend Pipeline
using NAT
Step 1 -
From the Main Edit Menu, select Configure
and enter the following settings:
Switch Type=NI-1 (or as obtained from your ISDN
provider)
Chan Usage=Switch/Switch
My Num A=(put in your 1st local 7 digit phone number)
My Num B=(put in your 2nd local 7 digit phone number if 128k, leave
blank if 64k)
SPID 1=(your 1st SPID number assigned to you by your ISDN provider,
generally the 9 digit area code and phone number followed by 0101)
SPID 2=(your 2nd SPID number assigned to you by your ISDN provider if
128k, leave blank if 64k, generally the 9 digit area code and phone
number followed by 0101)
Ans Voice Call=No
My Name= (the user id provided by KCnet)
My Addr=(enter any reserved, vaild IP address such as
192.168.100.100/24)
Rem Name=KCnet
Rem Addr=(100.100.100.100/24)
Dial #=(phone number assigned by KCnet)
Route=IP
Bridge=No
Send Auth=PAP
Send PW=*****
Recv Auth=None
Recv PW=N/A
Save=(go ahead and save your changes)
Step 2 - From the Main Edit Menu,
select Ethernet, then select Static
Rtes, and finally select Default and enter the
following settings:
Name=Default
Active=Yes
Dest=0.0.0.0/0
Gateway=0.0.0.0/0
Metric=1
Preference=100
Private=Yes
Step 3 - From the Main Edit Menu,
select Ethernet, then select
Mod Config and enter the following
settings:
NAT Routing=Yes
NAT Profile=KCnet
NAT Lan=Single IP addr
Step 4 - From the Main Edit Menu,
select Ethernet, then select
Mod Config, and finally select Ether options
and enter the following settings:
IP Adrs=192.168.100.100
2nd Adrs=(leave at default setting)
RIP=Off
RIP2 Use Multicast=(leave at default setting)
Ignore Def Rt=(leave at default setting)
Proxy Mode=Off
Filter=(leave at default setting)
IPX Frame=(leave at default setting)
IPX Enet#=(leave at default setting)
IPX Pool#=(leave at default setting)
IPX SAP Filter=(leave at default setting)
IPX SAP Proxy=(leave at default setting)
IPX SAP Proxy Net#1=(leave at default setting)
IPX SAP Proxy Net#2=(leave at default setting)
IPX SAP Proxy Net#3=(leave at default setting)
Handle IPX Type20=(leave at default setting)
Miscellaneous
Settings Support
Home
|
